I Designed It, I Built It

This is a welding cart I made myself. My work demands often switching from TIG welding to MIG/MAG and sometimes I even need both processes. So the hassle was having them on different carts. This really neglected my workplace and efficiency. So I designed this welding cart for myself. Problems I wanted to eliminate where:

• I wanted 2 Gas bottles side by side (Argon for TIG and Mixed Gas for MIG/MAG) with easy securing.
• Before I had to always lift the 50L bottles, now I designed them low enough so I could just "roll" them on without dangering my lower back while lifting.
• I needed some Table space to keep my drawings and other miscellaneous stuff
• I needed some containing place for my TIG rods so I added little hooks and front hooks I added a handscrew for securing them in the place and if the welding machine needs some maintenance I just remove the rods and I will have easy access to remove panels of the machine.
• Some solution to keep my cables organized so I added cable hooks on the right side
• Containing place for my angle grinder so I built this tool organizer on the left side, which is good for keeping pliers, files, etc. there too.
• The PVC hose for air pressure was always taking up space so I needed some way to keep it out of sight. I installed hose clamps in the bottom of the lower table and installed the spiral hose in the front to keep it out of the way if I don't need it.

Grabcad model

TIG+MIG/MAG Welding Cart/Trolley

This is a welding cart/trolley I made for my welders. You can install 2x 50L gas balloons, 6x TIG rod containers, 1x MIG/MAG machines, 1 or 2 TIG welders. Another add-ons are the toolholders and wide cable hooks. Top of the cart is a great work table for extra space.

I added some reinforcement plate for back wheel to minimize chance of flexing and welded short spacer over a weld so the wheel wouldn't wobble while moving

clamps to move the hose under the table

easy access for wire

my workplace before

my workplace now